Alcatel-Lucent 7210 SAS M - Basic Configuration

Configuring a VPRN Service with CLI
Page 566 7210 SAS M Services Guide
Basic Configuration
The following fields require specific input (there are no defaults) to configure a basic VPRN
service:
• Customer ID (refer to Configuring Customers on page 69)
• Specify interface parameters
• Specify spoke SDP parameters
The following example displays a sample configuration of a VPRN service.
*A:ALA-1>config>service>vprn# info
----------------------------------------------
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
autonomous-system 10000
route-distinguisher 10001:1
auto-bind ldp
vrf-target target:10001:1
interface "to-ce1" create
address 11.1.0.1/24
exit
sap 1/1/10:1 create
ingress
qos 100
exit
egress
qos 1010
filter ip 10
exit
exit
exit
exit
static-route 6.5.0.0/24 next-hop 10.1.1.2
bgp
router-id 10.0.0.1
group "to-cel"
export "vprnBgpExpPolCust1"
peer-as 65101
neighbor 10.1.1.2
exit
exit
exit
no shutdown
----------------------------------------------
*A:ALA-1>config>service>vprn#