Virtual Leased Line Services
7210 SAS M Services Guide Page 201
VLL Services Command Reference
Command Hierarchies
• Cpipe Service Configuration Commands on page 201
• Epipe Service Configuration Commands on page 203
Cpipe Service Configuration Commands
Note: Cpipe service configuration commands are not supported on 7210 SAS M devices
configured in access uplink mode.
config
—service
— cpipe service-id [customer customer-id] [vpn vpn-id] [vc-type {satop-e1 | satop-t1 | cesopsn
| cesopsn-cas}] [create]
—no cpipe service-id
— description description-string
—no description [description-string]
— endpoint endpoint-name [create]
—no endpoint endpoint-name
— active-hold-delay active-endpoint-delay
—no active-hold-delay
— description description-string
—no description [description-string]
— revert-time revert-time infinite
—no revert-time
— sap sap-id [no-endpoint] [create]
— sap sap-id endpoint endpoint-name [create]
—no sap sap-id
— [no] service-name
—
accounting-policy acct-policy-id
—no accounting-policy [acct-policy-id]
— cem
— packet jitter-buffer milliseconds [payload-size bytes]
— packet payload-size bytes
—no packet
— [no] report-alarm [stray] [malformed] [pktloss] [overrun]
[underrun] [rpktloss] [rfault] [rrdi]
—[no] rtp-header
— [no] collect-stats
— description description-string
—no description [description-string]
— ingress
— [no] qos [policy-id]
— service-mtu octets
—no service-mtu
To Next Page
Loading...
