Virtual Leased Line Services
7210 SAS M Services Guide Page 217
Values 1 — 2147483647
Default null (0)
svc-sap-type — Specifies the type of service and allowed SAPs in the service.
null-star — Specifies that the allowed SAP in the service that can be Null SAP, dot1q Default SAP,
Q.* SAP or Default QinQ SAP (also known as *.* SAP). Supported only in 7210 SAS-M access-
uplink mode.
dot1q — Specifies that the allowed SAP in the service are Dot1q SAPs and dot1q explicit null SAPs.
Supported only in 7210 SAS-M access-uplink mode.
dot1q-preserve — Specifies that the allowed SAP in the service are Dot1q. The Dot1q ID is not
stripped after packets matches the SAP. Supported only in 7210 SAS-M access-uplink mode.
dot1q-range — Specifies that the access SAP in the service can use VLAN ranges as the SAP tags.
The VLAN ranges are configured using the configure> connection-profile CLI command. On
ingress of the access dot1q SAP using VLAN ranges, the outermost tag is not removed before
forwarding. Supported in both 7210 SAS-M network and access-uplink mode.
any — When svc-sap-type is set to any, for a NULL SAP, the system processes and forwards only
packets with no VLAN tag (that is, untagged). All other packets with one or more VLAN tags
(even those with priority tag only) are not processed and dropped. Users can use the service with
svc- sap-type set to null-star, to process and forward packets with one or more tags (including
priority tag) on a null SAP.
qinq-inner-tag-preserve — When svc-sap-type is set to this value, an Epipe service processes and
forwards packets received with 3 tags on a QinQ SAP. Please read the Epipe chapter above to
learn more about the support available and restrictions that apply. Supported only in 7210 SAS-
M network mode.
Default null-star
customer-vid vlan-id — Defines the dot1q VLAN ID to be specified while creating the local Dot1q
SAP for svc-sap-type dot1q-preserve.
Values 1 — 4094
create — Keyword used to create the service instance. The create keyword requirement can be
enabled/disabled in the environment>create context.
endpoint
Syntax [no] endpoint endpoint-name
Context config>service>cpipe
config>service>epipe
Description This command configures a service endpoint.
Parameters endpoint-name — Specifies an endpoint name.
To Next Page
Loading...
