VLL Service Configuration Commands
Page 216 7210 SAS M Services Guide
create — Keyword used to create the service. The create keyword requirement can be enabled/
disabled in the environment>create context.
epipe
Syntax epipe service-id [customer customer-id] [create][vpn vpn-id] (for 7210 SAS-M in Network
mode)
epipe service-id [customer customer-id] [create] [vpn vpn-id][customer customer-id]
[create] [vpn vpn-id] [svc-sap-type {{null-star|dot1q-preserve|any|dot1q-range|qinq-inner-
tag-preserve}]] [customer-vid vlan-id] (for 7210 SAS-M in Access uplink mode)
no epipe service-id
Context config>service
Description This command configures an Epipe service instance. This command is used to configure a point-to-
point epipe service. An Epipe connects two endpoints defined as Service Access Points (SAPs). Both
SAPs may be defined in one 7210 SAS.
No MAC learning or filtering is provided on an Epipe.
When a service is created, the customer keyword and customer-id must be specified and associates
the service with a customer. The customer-id must already exist having been created using the
customer command in the service context. Once a service has been created with a customer
association, it is not possible to edit the customer association. The service must be deleted and
recreated with a new customer association.
Once a service is created, the use of the customer customer-id is optional for navigating into the
service configuration context. Attempting to edit a service with the incorrect customer-id specified
will result in an error.
By default, no epipe services exist until they are explicitly created with this command.
The no form of this command deletes the epipe service instance with the specified service-id. The
service cannot be deleted until the service has been shutdown.
service-id-epipe
Parameters service-id — The unique service identification number or string identifying the service in the service
domain. This ID must be unique to this service and may not be used for any other service of any
type. The service-id must be the same number used for every 7210 SAS on which this service is
defined.
Values service-id: 1 — 2147483648
svc-name: 64 characters maximum
epipe customer
customer customer-id — Specifies the customer ID number to be associated with the service. This
parameter is required on service creation and optional for service editing or deleting.
Values 1 — 2147483647
vpn
vpn vpn-id — Specifies the VPN ID number which allows you to identify virtual private networks
(VPNs) by a VPN ID. If this parameter is not specified, the VPN ID uses the same service ID
number.
To Next Page
Loading...
