Alcatel-Lucent 7210 SAS M - Page 215

Virtual Leased Line Services
7210 SAS M Services Guide Page 215
VLL Global Commands
cpipe
Syntax cpipe service-id [customer customer-id] [vpn vpn-id] [vc-type {satop-e1 | satop-t1 |
cesopsn | cesopsn-cas}] [create]
no cpipe service-id
Context config>service
Description This command configures a Circuit Emulation Services instance. When a service is created, the
customer keyword and customer-id must be specified and associates the service with a customer. The
customer-id must already exist having been created using the customer command in the service
context. Once a service has been created with a customer association, it is not possible to edit the
customer association. The service must be deleted and recreated with a new customer association.
Once a service is created, the use of the customer customer-id is optional for navigating into the
service configuration context. Attempting to edit a service with the incorrect customer-id specified
will result in an error.
By default, no services exist until they are explicitly created with this command.
The no form of this command deletes the service instance with the specified service-id. The service
cannot be deleted until the service has been shutdown.
Parameters service-id — The unique service identification number or string identifying the service in the service
domain. This ID must be unique to this service and may not be used for any other service of any
type. The service-id must be the same number used for every 7210 SAS on which this service is
defined.
Values service-id: 1 — 2147483647
cpipe customer
customer customer-id — Specifies the customer ID number to be associated with the service. This
parameter is required on service creation and optional for service editing or deleting.
Values 1 — 2147483647
vpn
vpn vpn-id — Specifies the VPN ID number which allows you to identify virtual private networks
(VPNs) by a VPN ID. If this parameter is not specified, the VPN ID uses the same service ID
number.
Values 1 — 2147483647
Default null (0)
vc-type — The vc-type defines the type of unstructured or structured circuit emulation service to be
configured.
Values satop-e1: unstructured E1 circuit emulation service
satop-t1: unstructured DS1 circuit emulation service
cesopsn: basic structured n*64 kbps circuit emulation service
cesopsn-cas: structured n*64 kbps circuit emulation service with signaling
Default cesopsn