VLL Service Configuration Commands
Page 220 7210 SAS M Services Guide
octets — The size of the MTU in octets, expressed as a decimal integer, between 1 — 9194.
service-name
Syntax service-name service-name
no service-name
Context config>service>epipe
config>service>cpipe
Description This command configures an optional service name, up to 64 characters in length, which adds a name
identifier to a given service to then use that service name in configuration references as well as
display and use service names in show commands throughout the system. This helps the service
provider/administrator to identify and manage services within the 7750 SR, 7450 ESS and 7710 SR
platforms.
All services are required to assign a service ID to initially create a service. However, either the service
ID or the service name can be used o identify and reference a given service once it is initially created.
Parameters service-name — Specifies a unique service name to identify the service. Service names may not begin
with an integer (0-9).
service-mtu-check
Note:This command is supported on 7210 SAS-M in Network mode.
Syntax [no] service-mtu-check
Context config>service>epipe
Description The no form of this command disables the service MTU check.
Disabling service MTU check allows the packets to pass to the egress if the packet length is lesser
than or equal to the MTU configured on the port. The length of the packet sent from a SAP is limited
only by the access port MTU. In case of a pseudowire the length of a packet is limited by the network
port MTU (including the MPLS encapsulation).
SAP VC-Type Example
Service MTU
Advertised
MTU
Ethernet 1514 1500
Ethernet (with preserved dot1q) 1518 1504
VPLS 1514 1500
VPLS (with preserved dot1q) 1518 1504
VLAN (dot1p transparent to MTU value) 1514 1500
VLAN (Q-in-Q with preserved bottom Qtag) 1518 1504
To Next Page
Loading...
Need help?
General
