VLL Service Configuration Commands
Page 224 7210 SAS M Services Guide
Context config>service>epipe>sap
Description This command applies a time-based policy (filter or QoS policy) to the service SAP. The suite name
must already exist in the config>cron context.
Default no tod-suite
Parameters tod-suite-name — Specifies collection of policies (ACLs, QoS) including time-ranges that define the
full or partial behavior of a SAP. The suite can be applied to more than one SAP.
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>epipe>sap
config>service>epipe>spoke-sdp
Description This command creates the accounting policy context that can be applied to a SAP.
An accounting policy must be defined before it can be associated with a SAP. If the policy-id does not
exist, an error message is generated.
A maximum of one accounting policy can be associated with a SAP at one time. Accounting policies
are configured in the config>log context.
The no form of this command removes the accounting policy association from the SAP, and the
acccounting policy reverts to the default.
Default Default accounting policy.
Parameters acct-policy-id — Enter the accounting policy-id as configured in the config>log>accounting-policy
context.
Values 1 — 99
description
Syntax description description-string
no description
Context config>service>epipe>sap
config>service>epipe>spoke-sdp
Description This command defines an ASCII string associated with egress-multicast-group-name.
The no form of the command removes an existing description string from egress-multicast-group.
Default none
To Next Page
Loading...
