Subscriber Services
7210 SAS M Services Guide Page 97
Customer Management Commands
customer
Syntax customer customer-id [create]
no customer customer-id
Context config>service
Description This command creates a customer ID and customer context used to associate information with a
particular customer. Services can later be associated with this customer at the service level.
Each customer-id must be unique. The create keyword must follow each new customer customer-id
entry.
Enter an existing customer customer-id (without the create keyword) to edit the customer’s
parameters.
Default customer 1 always exists on the system and cannot be deleted.
The no form of this command removes a customer-id and all associated information. Before
removing a customer-id, all references to that customer in all services must be deleted or changed to a
different customer ID.
Parameters customer-id — Specifies the ID number to be associated with the customer, expressed as an integer.
Values 1 — 2147483647
contact
Syntax contact contact-information
no contact contact-information
Context config>service>customer
Description This command allows you to configure contact information for a customer.
Include any customer-related contact information such as a technician’s name or account contract
name.
Default No contact information is associated with the customer-id.
The no form of this command removes the contact information from the customer ID.
Parameters contact-information — The customer contact information entered as an ASCII character string up to
80 characters in length. If the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes. Any printable, seven bit ASCII characters may be
used within the string.
To Next Page
Loading...
Need help?
General
