Alcatel-Lucent 7210 SAS M - Page 91

Subscriber Services
7210 SAS M Services Guide Page 91
SDP Commands (Applicable only to 7210 SAS-M in network mode)
Note : SDP commands are not applicable for 7210 SAS-M devices configured in Access
Uplink mode.
config
—service
— sdp sdp-id [mpls] [create]
—no sdp sdp-id
— accounting-policy acct-policy-id
—no accounting-policy
— collect-stats acct-policy-id
—no collect-stats
— [no] adv-mtu-override
—[no] bgp-tunnel
— [no] collect-stats
— description description-string
—no description
— far-end ip-address
—no far-end
— keep-alive
— hello-time seconds
—no hello-time
— hold-down-time seconds
—no hold-down-time
— max-drop-count count
—no max-drop-count
— message-length octets
—no message-length
— [no] shutdown
— timeout timeout
—no timeout
— [no] ldp
— metric metric
— no
metric
— [no] lsp lsp-name
— path-mtu octets
—no path-mtu
— [no] shutdown
— signaling [off | tldp]
SAP Commands for 7210 SAS-M in Network mode
config
—service
— epipe
— sap sap-id [create]no sap sap-id
— ies
— sap sap-id [create]