SDP Keepalive Commands
Page 110 7210 SAS M Services Guide
Description This command configures the number of consecutive SDP keepalive failed request attempts or remote
replies that can be missed after which the SDP is operationally downed. If the max-drop-count
consecutive keepalive request messages cannot be sent or no replies are received, the SDP-ID will be
brought operationally down by the keepalive SDP monitoring.
The no form of this command reverts the max-drop-count count value to the default settings.
Default max-drop-count 3
Parameters count — The number of consecutive SDP keepalive requests that are failed to be sent or replies
missed, expressed as a decimal integer.
Values 1 — 5
message-length
Syntax message-length octets
no message-length
Context config>service>sdp>keep-alive
Description This command configures the SDP monitoring keepalive request message length transmitted.
The no form of this command reverts the message-length octets value to the default setting.
Default 0 — The message length should be equal to the SDP’s operating path MTU as configured in the path-
mtu command. If the default size is overridden, the actual size used will be the smaller of the
operational SDP-ID Path MTU and the size specified.
octets — The size of the keepalive request messages in octets, expressed as a decimal integer. The
size keyword overrides the default keepalive message size.
Values 40 — 9198
timeout
Syntax timeout timeout
no timeout
Context config>service>sdp>keep-alive
Description This command configures the time interval that the SDP waits before tearing down the session.
Default 5
Parameters timeout — The timeout time, in seconds.
Values 1 — 10
To Next Page
Loading...
Need help?
General
