Alcatel-Lucent 7210 SAS M - Page 111

Subscriber Services
7210 SAS M Services Guide Page 111
ETH-CFM Configuration Commands
eth-cfm
Syntax eth-cfm
Context config
Description This command enables the context to configure 802.1ag CFM parameters.
mep
Syntax mep mep-id domain md-index association ma-index vlan vlan-id]
no mep mep-id domain md-index association ma-index
Context config>port>ethernet>
config>lag>
config>router>if>
Description This command provisions the maintenance endpoint (MEP).
The no form of the command reverts to the default values.
Parameters mep-id — Specifies the maintenance association end point identifier.
Values 1 — 81921
md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
vlan-id — Specific to tunnel facility MEPs which means this option is only applicable to the
lag>eth-cfm> context. Used to specify the outer vlan id of the tunnel.
Values 1 — 4094
ais-enable
Syntax [no] ais-enable
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
Description This command enables the reception of AIS messages.
The no form of the command reverts to the default values.