ETH-CFM Configuration Commands
Page 112 7210 SAS M Services Guide
client-meg-level
Syntax client-meg-level [[level [level ...]]
no client-meg-level
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
Description This command configures the client maintenance entity group (MEG) level(s) to use for AIS message
generation. Up to 7 levels can be provisioned with the restriction that the client MEG level must be
higher than the local MEG level. Only the lowest client MEG level will be used for facility MEPs.
The no form of the command reverts to the default values.
Parameters level — Specifies the client MEG level.
Values 1 — 7
Default 1
interval
Syntax interval {1 | 60}
no interval
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
Description This command specifies the transmission interval of AIS messages in seconds.
The no form of the command reverts to the default values.
Parameters 1 | 60 — The transmission interval of AIS messages in seconds.
Default 1
priority
Syntax priority priority-value
no priority
Context config>port>ethernet>eth-cfm>mep>ais-enable
config>lag>eth-cfm> mep>ais-enable
Description This command specifies the priority of the AIS messages generated by the node.
The no form of the command reverts to the default values.
Parameters priority-value — Specify the priority value of the AIS messages originated by the node.
Values 0 — 7
Default 7