EasyManuals Logo

Alcatel-Lucent 7210 SAS M Service Guide

Alcatel-Lucent 7210 SAS M
952 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
Subscriber Services
7210 SAS M Services Guide Page 113
ccm-enable
Syntax [no] ccm-enable
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
Description This command enables the generation of CCM messages.
The no form of the command disables the generation of CCM messages.
ccm-ltm-priority
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
Description This command specifies the priority of the CCM and LTM messages transmitted by the MEP. Since
CCM does not apply to the Router Facility MEP only the LTM priority is of value under that context.
The no form of the command reverts to the default values.
Default priority — Specifies the priority value
Values 0 — 7
Default 7
eth-test-enable
Syntax [no] eth-test-enable
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
Description For this test to work, operators need to configure ETH-test parameters on both sender and receiver
nodes. The ETH-test then can be done using the following OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index association ma-index [priority
priority] [data-length data-length]
The no form of the command disables eth-test capabilities.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS M and is the answer not in the manual?

Alcatel-Lucent 7210 SAS M Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS M
CategorySwitch
LanguageEnglish

Related product manuals