ETH-CFM Configuration Commands
Page 114 7210 SAS M Services Guide
Context config>port>ethernet>eth-cfm>mep>eth-test>
config>lag>eth-cfm>mep>eth-test>
config>router>if>eth-cfm>mep>eth-test
Description This command specifies the test pattern of the ETH-TEST frames. This does not have to be
configured the same on the sender and the receiver.
The no form of the command reverts to the default values.
Parameters all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Default all-zeros
low-priority-defect
Syntax low-priority-defect {allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context config>port>ethernet>eth-cfm>mep>eth-test>
config>lag>eth-cfm>mep>eth-test>
Description This command specifies the lowest priority defect that is allowed to generate a fault alarm. This
setting is also used to determine the fault state of the MEP which, well enabled to do so, causes a
network reaction.
Default macRemErrXcon
Values allDef DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
macRemErrXcon
Only DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
mac-address
Syntax mac-address mac-address
no mac-address
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of the command reverts to the MAC address of the MEP back to the default, that of the
port, since this is SAP based.
To Next Page
Loading...
Need help?
General
