Subscriber Services
7210 SAS M Services Guide Page 99
Pseudowire Commands
pw-template
Syntax [no] pw-template policy-id [use-provisioned-sdp] [create]
Context config>service
Description This command configures an SDP template.
Parameters use-provisioned-sdp — Specifies whether to use an already provisioned SDP. When specified, the
tunnel manager will be consulted for an existing active SDP. Otherwise, the default SDP template
will be used to use for instantiation of the SDP.
create — This keyword is required when first creating the configuration context. Once the context is
created, it is possible to navigate into the context without the create keyword.
control-word
Syntax [no] control-word
Context config>service>pw-template
Description This command enables the use of the control word on pseudowire packets in VPLS and enables the
use of the control word individually on each mesh-sdp or spoke-sdp. By default, the control word is
disabled. When the control word is enabled, all VPLS packets, including the BPDU frames, are
encapsulated with the control word when sent over the pseudowire. The T-LDP control plane
behavior is the same as in the implementation of control word for VLL services. The configuration
for the two directions of the Ethernet pseudowire should match.
The no form of the command reverts the mesh SDP or spoke-sdp to the default behavior of not using
the control word.
Default no control-word
To Next Page
Loading...
Need help?
General
