Alcatel-Lucent 7210 SAS M Service Guide

IES Service Configuration Commands
7210-SAS M Services Guide Page 539
command instead of the sap command. The loopback flag cannot be set on an interface where a SAP
is already defined and a SAP cannot be defined on a loopback interface.
Default none
static-arp
Syntax static-arp ip-address ieee-mac-address
no static-arp ip-address
Context config>service>ies>if
Description This command configures a static address resolution protocol (ARP) entry associating a subscriber IP
address with a MAC address for the core router instance. This static ARP appears in the core routing
ARP table. A static ARP can only be configured if it exists on the network attached to the IP
interface.
If an entry for a particular IP address already exists and a new MAC address is configured for the IP
address, the existing MAC address will be replaced with the new MAC address.
The no form of the command removes a static ARP entry.
Default None
Parameters ip-address — Specifies the IP address for the static ARP in IP address dotted decimal notation.
ieee-mac-address — Specifies the 48-bit MAC address for the static ARP in the form
aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
Allowed values are any non-broadcast, non-multicast MAC and non-IEEE reserved MAC
addresses.
vpls
Syntax vpls service-name
Context config>service
config>service>ies>if
Description The vpls command, within the IP interface context, is used to bind the IP interface to the specified
service name.
The system does not attempt to resolve the service name provided until the IP interface is placed into
the administratively up state (no shutdown). Once the IP interface is administratively up, the system
scans the available VPLS services that have the allow-ip-int-binding flag set for a VPLS service
associated with the name. If the service name is bound to the service name when the IP interface is
already in the administratively up state, the system will immediately attempt to resolve the given
name.
If a VPLS service is found associated with the name and with the allow-ip-int-binding flag set, the IP
interface will be attached to the VPLS service allowing routing to and from the service virtual ports
once the IP interface is operational.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English