IES Filter Commands
Page 546 7210-SAS M Services Guide
IES Filter Commands
filter
Syntax filter ip ip-filter-id
Context config>service>ies>if>sap>egress
config>service>ies>if>sap>ingress
Description This command associates a filter policy with an ingress or egress Service Access Point (SAP). Filter
policies control the forwarding and dropping of packets based on the matching criteria.
The filter command is used to associate a filter policy with a specified ip-filter-id with an ingress or
egress SAP. The filter policy must already be defined before the filter command is executed. If the
filter policy does not exist, the operation will fail and an error message returned.
In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One exception
is non-IP packets are not applied to the match criteria, so the default action in the filter policy applies
to these packets.
The no form of this command removes any configured filter ID association with the SAP. The filter
ID itself is not removed from the system.
Special Cases IES — Only IP filters are supported on an IES IP interface, and the filters only apply to routed
traffic.
Parameters ip — Keyword indicating the filter policy is an IP filter.
ip-filter-id — Specifies the ID for the IP filter policy. Allowed values are an integer in the range of 1
and 65535 that corresponds to a previously created IP filter policy in the configure>filter>ip-
filter context.
Values 1 — 65535
egress
Syntax egress
Context config>service>ies>if>sap
Description This command enables the context to apply egress policies.
To Next Page
Loading...
Need help?
General
