Alcatel-Lucent 7210 SAS Series - Page 310

IP QoS Policy Match Commands
Page 320 7210 SAS D, E, K OS Quality of Service Guide
dst-ip
Syntax dst-ip {ip-address/mask | ip-address netmask}
no dst-ip
Context config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description This command configures a destination address range to be used as a SAP QoS policy match criterion.
To match on the destination address, specify the address and its associated mask, e.g., 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 can also be used.
The no form of this command removes the destination IP address match criterion.
Default none
Parameters ip-address — The IP address of the destination IP or IPv6 interface. This address must be unique within the
subnet and specified in dotted decimal notation.
Values ipv4-prefix: a.b.c.d
ipv4-prefix-length: 0 -- 32
ipv6-prefix: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0..FFFF]H
d: [0..255]D
ipv6-prefix-length: 0 -- 128
netmask Specifies the subnet mask in dotted decimal notation.
Values 0.0.0.0 - 255.255.255.255
dst-port
Syntax dst-port {eq} dst-port-number
no dst-port
Context config>qos>sap-ingress
config>qos>sap-ingress>ip-criteria>entry>match
Description This command configures a destination TCP or UDP port number or port range for a SAP QoS policy match
criterion.
The no form of this command removes the destination port match criterion.
Default none
Parameters eq dst-port-number — The TCP or UDP port numbers to match specified as equal to (eq) to the destination
port value specified as a decimal integer.
Values 1 — 65535 (decimal hex or binary)