Page 398 7210 SAS E OS Quality of Service Guide
Defines the queue priority. The queue priority is used by the scheduler to determine the order of
service in both the within-cir loop and within-pir loop. Higher priority queues are serviced before
lower priority queues.
The no form of the command sets this to the default value.
Default 1
Parameters level —
Specifies the priority of the queue.
Values [1..4]
slope-policy
Syntax [no] slope-policy name
Context config>qos>sap-ingress>queue
config>qos>sap-egress>queue
Description
The slope-policy command is used to override the default slope-policy configuration for the
queue. The specified slope-policy-name must exist as a current slope policy name. If the slope
policy does not exist, the slope-policy command will fail. If a slope policy is currently associated
with a queue, the slope policy cannot be removed from the system.
The slope policy contains the ring and non-ring High and Low WRED slope definitions that will
be used by the queue. The non-ring slopes are used by the traffic received on access SAP ingress
and sent out of access SAP egress queues. The ring slopes are used by the traffic received on
access-uplink port ingress and sent out of access-uplink port egress queues.
If the slope-policy command is not executed or the no slope policy command is executed, the
default slope policy will be associated with the queue.
The no form of the command restores the default slope policy to the queue.
Parameters name —
The name parameter is required and must specify an existing slope policy name. If slope-
policy-name does not exist, the slope-policy command will fail.
Values 32 chars max
To Next Page
Loading...
Need help?
General
