7210 SAS E OS Quality of Service Guide Page 399
queue
Syntax queue queue-id create
Context config>qos>sap-egress
Description
This command creates the context to modify Queue parameters associated with a particular queue.
On 7210 SAS-K, the queue-ID to FC map is user defined.
The no form of this command is not supported
Default none
Parameters
queue-id — Specifies the id of the queue.
Values 1 — 8
create — Mandatory keyword to create a network queue policy.
weight
Syntax [no] weight weight
Context config>qos>sap-egress
Description
Platforms Supported: 7210 SAS-K.
Allows users to specify the weight of the queue.
The configured weight determines the proportion of available bandwidth that is given to this queue
in comparison to other queues contending for bandwidth at the same priority level.
The no form of the command sets the weight to default of one.
Default
1
Parameters weight — Specifies the value for the weight parameter. It is an integer value which specifies the proportion
of available bandwidth to be allocated to this queue relative to other queues.
Values 1 — 100
sap-egress
Syntax sap-egress policy-id [create]
Context config>qos
Description
This command enables the context to configure a SAP Egress policy. The SAP egress policy
determines the QoS treatment to packets at service egress.
To Next Page
Loading...
Need help?
General
