Alcatel-Lucent 7210 SAS Series - Page 444

Slope Policy QoS Policy Commands (for 7210 SAS-E devices)
Page 500 7210 SAS D, E, K OS Quality of Service Guide
Slope Policy QoS Policy Commands (for 7210 SAS-E
devices)
high-slope
Syntax [no] high-slope
Context config>qos>slope-policy
Description
The high-slope context contains the commands and parameters for defining the high priority
Random Early Detection (RED) slope graph. Each buffer pool supports a high priority RED slope
for managing access to the shared portion of the buffer pool for high priority or in-profile packets.
The high-slope parameters can be changed at any time and the affected buffer pool high priority
RED slopes will be adjusted appropriately.
The no form of this command restores the high slope configuration commands to the default
values. If the commands within high-slope are set to the default parameters, the high-slope node
will not appear in save config and show config output unless the detail parameter is present.
low-slope
Syntax [no] low-slope
Context config>qos>slope-policy
Description
The low-slope context contains the commands and parameters for defining the low priority
Random Early Detection (RED) slope graph. Each buffer pool supports a low priority RED slope
for managing access to the shared portion of the buffer pool for low priority or out-of-profile
packets.
The low-slope parameters can be changed at any time and the affected buffer pool low priority
RED slopes must be adjusted appropriately.
The no form of this command restores the low slope configuration commands to the default
values. If the leaf commands within low-slope are set to the default parameters, the low-slope
node will not appear in save config and show config output unless the detail parameter is present.