Services Overview
7705 SAR OS Services Guide Page 119
The no form of this command reverts the hold-down-time seconds value to the default setting.
Parameters seconds — the time in seconds, expressed as a decimal integer, the sdp-id will remain in the
operationally down state after an SDP keepalive error before it is eligible to enter the
operationally up state. A value of 0 indicates that no hold-down-time will be enforced for sdp-id.
Default 10
Values 0 to 3600
max-drop-count
Syntax max-drop-count count
no max-drop-count
Context config>service>sdp>keep-alive
Description This command configures the number of consecutive SDP keepalive failed request attempts or remote
replies that can be missed after which the SDP is operationally downed.
If the max-drop-count consecutive keepalive request messages cannot be sent or no replies are
received, the SDP-ID will be brought operationally down by the keepalive SDP monitoring.
The no form of this command reverts the max-drop-count count value to the default settings.
Parameters count — the number of consecutive SDP keepalive requests that can fail to be sent or replies missed
before the SDP is brought down, expressed as a decimal integer
Default 3
Values 1 to 5
message-length
Syntax message-length octets
no message-length
Context config>service>sdp>keep-alive
Description This command configures the size of SDP monitoring keepalive request messages transmitted on the
SDP.
The no form of this command reverts the message-length octets value to the default setting.
Parameters octets — the size of keepalive request messages in octets, expressed as a decimal integer. The size
keyword overrides the default keepalive message size.
The message length should be equal to the SDP operating path MTU as configured in the
path-
mtu
command.
To Next Page
Loading...
