Alcatel-Lucent 7705 - Page 241

VLL Services
7705 SAR OS Services Guide Page 241
ipipe
Syntax ipipe service-id [customer customer-id] [create] [vpn vpn-id] [vc-switching]
[no] ipipe service-id
Context config>service
Description This command configures an IP interworking service. An Ipipe can connect an Ethernet or
PPP/MLPPP SAP over an MPLS or IP network to a remote Ethernet or PPP/MLPP SAP.
Parameters service-id — uniquely identifies a service in the service domain. This ID must be unique to this
service and may not be used for any other service of any type. The service-id must be the same
number used for every 7705 SAR on which this service is defined.
Values 1 to 2147483647
customer-id — specifies the customer ID number to be associated with the service. This parameter is
required on service creation and optional for service editing or deleting.
Values 1 to 2147483647
create — keyword used to create an Ipipe. The create keyword requirement can be enabled/disabled
in the environment>create context.
vpn-id — specifies the VPN ID number that allows you to identify virtual private networks (VPNs) by
a VPN ID. If this parameter is not specified, the VPN ID uses the same service ID number.
Values 1 to 2147483647
Default null (0)
vc-switching — specifies that pseudowire switching signaling is used for the spoke SDPs configured
for this service
endpoint
Syntax [no] endpoint endpoint-name
Context config>service>apipe
config>service>cpipe
config>service>epipe
config>service>ipipe
Description This command provides access to the service endpoint context.
Parameters endpoint-name — specifies an endpoint name (up to 32 alphanumeric characters)