VLL Services Command Reference
Page 242 7705 SAR OS Services Guide
revert-time
Syntax revert-time [revert-time | infinite]
no revert-time
Context config>service>apipe>endpoint
config>service>cpipe>endpoint
config>service>epipe>endpoint
config>service>ipipe>endpoint
Description This command configures the time to wait before reverting back to the primary spoke SDP defined on
this service endpoint, after having switched over to a backup spoke SDP after a failure of the primary
spoke SDP.
Parameters revert-time — specifies the time, in seconds, to wait before reverting to the primary SDP
Values 0 to 600
infinite — causes the endpoint to be non-revertive
standby-signaling-master
Syntax [no] standby-signaling-master
Context config>service>apipe>endpoint
config>service>cpipe>endpoint
config>service>epipe>endpoint
config>service>ipipe>endpoint
Description This command sends the pseudowire standby bit (value 0x00000020) to the targeted LDP (TLDP)
peer whenever a spoke-SDP of the endpoint is selected as a standby (see
precedence). This bit
informs the far end that the pseudowire is not currently active.
Default no standby-signaling-master
service-mtu
Syntax service-mtu octets
no service-mtu
Context config>service>apipe
config>service>cpipe
config>service>epipe
config>service>ipipe
Note: The infinite option (for non-revertive behavior) does not apply to Cpipes.
To Next Page
Loading...
