VLL Services
7705 SAR OS Services Guide Page 259
SAP QoS and IP Filter Policy Commands
egress
Syntax egress
Context config>service>apipe>sap
config>service>cpipe>sap
config>service>epipe>sap
config>service>ipipe>sap
Description This command enables the context to configure egress SAP Quality of Service (QoS) policies.
If no sap-egress QoS policy is defined, the system default sap-egress QoS policy is used for egress
processing.
ingress
Syntax ingress
Context config>service>apipe>sap
config>service>cpipe>sap
config>service>epipe>sap
config>service>ipipe>sap
Description This command enables the context to configure ingress SAP QoS policies.
If no sap-ingress QoS policy is defined, the system default sap-ingress QoS policy is used for ingress
processing.
filter
Syntax filter ip ip-filter-id
no filter [ip ip-filter-id]
Context config>service>epipe>sap>ingress
config>service>ipipe>sap>ingress
Description This command associates an IP filter policy with an ingress Epipe or Ipipe SAP.
Filter policies control the forwarding and dropping of packets based on IP matching criteria. Only one
filter can be applied to a SAP at a time.
The ip-filter-id must already be defined before the filter command is executed. If the filter policy
does not exist, the operation will fail and an error message will be displayed.
To Next Page
Loading...
