VLL Services
7705 SAR OS Services Guide Page 263
vc-type — overrides the default VC type signaled for the spoke binding to the far end of the SDP. The
VC type is a 15-bit quantity containing a value that represents the type of VC. The actual
signaling of the VC type depends on the signaling parameter defined for the SDP. If signaling is
disabled, the vc-type command can still be used to define the dot1q value expected by the far-end
provider equipment. A change of the binding’s VC type causes the binding to signal the new VC
type to the far end when signaling is enabled.
VC types are derived according to IETF draft-martini-l2circuit-trans-mpls.
• The VC type value for Ethernet is 0x0005.
• The VC type value for an Ethernet VLAN is 0x0004.
Values ether | vlan
ether — defines the VC type as Ethernet. The ethernet and vlan keywords are mutually exclusive.
When the VC type is not defined, then the default is Ethernet for spoke SDP bindings. Defining
Ethernet is the same as executing no vc-type and restores the default VC type for the spoke SDP
binding.
vlan — defines the VC type as VLAN. The ethernet and vlan keywords are mutually exclusive.
When the VC type is not defined, then the default is Ethernet for spoke SDP bindings. The
VLAN VC-type requires at least one dot1Q tag within each encapsulated Ethernet packet
transmitted to the far end.
endpoint-name — specifies the name of the service endpoint
no-endpoint — removes a spoke SDP association
egress
Syntax egress
Context config>service>apipe>spoke-sdp
config>service>cpipe>spoke-sdp
config>service>epipe>spoke-sdp
config>service>ipipe>spoke-sdp
Description This command configures the egress SDP context.
ingress
Syntax ingress
Context config>service>apipe>spoke-sdp
config>service>cpipe>spoke-sdp
config>service>epipe>spoke-sdp
config>service>ipipe>spoke-sdp
Description This command configures the ingress SDP context.
To Next Page
Loading...
