Alcatel-Lucent 7705 - Page 312

VLL Services Command Reference
Page 312 7705 SAR OS Services Guide
LbNextSequence Displays the sequence number of the next LB transmission
LtNextSequence Displays the sequence number of the next Linktrace (LT) message
transmitted
LtRxUnexplained Displays the number of the unexplained Linktrace (LT) messages
ATM SAP Configuration Information
Ingress TD Profile The profile ID of the traffic descriptor applied to the ingress SAP
Egress TD Profile The profile ID of the traffic descriptor applied to the egress SAP
Alarm Cell
Handling
Indicates that OAM cells are being processed
OAM Termination Indicates whether this SAP is an OAM termination point
CEM SAP Configuration Information
Endpoint Type Specifies the type of endpoint
Bit-rate Specifies the number of DS0s or timeslots in the channel group
Payload Size Specifies the number of octets contained in the payload of a TDM
PW packet when the packet is transmitted
Jitter Buffer Specifies the size of the receive jitter buffer, expressed in
milliseconds
Use RTP Header Specifies whether RTP headers are used in CES packets (Yes or No)
CAS Framing Specifies the type of CAS framing
Effective PVDT Displays the peak-to-peak packet delay variation (PDV) used by the
circuit emulation service.
Since the operating system may adjust the jitter buffer setting in
order to ensure no packet loss, the configured jitter buffer value may
not be the value used by the system. The effective PVDT provides an
indication that the PVD has been adjusted by the operating system
(see
Jitter Buffer on page 154)
Cfg Alarm Specifies the alarms that have alarm reporting enabled
Alarm Status Indicates the current alarm state (for example, stray, malformed,
packet loss, overrun, underrun, remote packet loss, remote fault, or
remote RDI)
Table 40: Service-ID SAP Output Fields (Continued)
Label Description