VLL Services
7705 SAR OS Services Guide Page 311
LowestDefectPri Displays a configured value that defects are evaluated against
HighestDefect Displays the highest defect
Defect Flags Indicates the defect flags
Mac Address Displays the MAC address (the MAC address for a spoke SDP is the
system MAC address; for a SAP, it is the port MAC address)
CcmLtmPriority Displays the priority of the CCM Linktrace Message (LTM)
CcmTx Displays the number of CCM transmissions
CcmSequenceErr Displays the number of CCM sequence errors
DmrRepliesTx Displays the number of delay measurement replies transmitted
LmrRepliesTx Displays the number of loss measurement replies transmitted
Dual-Loss Test Displays the status of the dual-ended loss measurement test (enabled
or disabled)
Dual-Loss Thresh Displays the frame error threshold beyond which an alarm will be
raised. The threshold is expressed as a percentage.
Eth-Ais Displays the status of the ETH-AIS test (enabled or disabled)
Eth-Ais Rx Ais Indicates whether any ETH-AIS messages have been received
Eth-Ais Tx
Priorit*
Displays the priority value of a transmitted ETH-AIS frame
Eth-Ais Rx Interv* Indicates the interval of a received ETH-AIS frame
Eth-Ais Tx
Interva*
Displays the interval of a transmitted ETH-AIS frame
Eth-Ais Tx Counte* Displays the number of ETH-AIS frames that have been sent
Eth-Ais Tx Levels Indicates the MD level of transmitted ETH-AIS frames
Eth-Tst Indicates the status of the ETH-Test (enabled or disabled)
LbRxReply Displays the number of received loopback (LB) replies
LbRxBadOrder Displays the number of LB replies that have been received in the
wrong order
LbRxBadMsdu Displays the number of LB replies that have been received with the
wrong destination MAC address (MSDU = MAC Service Data Unit)
LbTxReply Displays the number of LBRs (loopback replies) transmitted out this
MEP
Table 40: Service-ID SAP Output Fields (Continued)
Label Description
To Next Page
Loading...
