Internet Enhanced Service
7705 SAR OS Services Guide Page 381
The no form of the command deletes the specified primary DNS address, secondary DNS address, or
both addresses from the IPCP extension peer-ip-address configuration.
Default no dns
Parameters ip-address — specifies a unicast IPv4 address for the primary DNS server to be signaled to the far end
of the associated PPP/MLPPP link via IPCP extensions
secondary ip-address — specifies a unicast IPv4 address for the secondary DNS server to be signaled
to the far end of the associated PPP/MLPPP link via IPCP extensions
peer-ip-address
Syntax peer-ip-address ip-address
no peer-ip-address
Context config>service>ies>interface>ipcp
Description This command defines the remote IP address to be assigned to the far end of the associated
PPP/MLPPP link via IPCP extensions. This command is only applicable if the associated SAP or port
is a PPP/MLPPP interface with an IPCP encapsulation.
The no form of the command deletes the IPCP extension peer-ip-address configuration.
Default no peer-ip-address (0.0.0.0)
Parameters ip-address — a unicast IPv4 address to be signaled to the far end of the associated PPP/MLPPP link
by IPCP extensions
mac
Syntax [no] mac ieee-address
Context config>service>ies>interface
Description This command assigns a specific MAC address to an IES IP interface.
The no form of the command returns the MAC address to the default value.
Default the physical MAC address associated with the Ethernet interface on which the SAP is configured
(default MAC address assigned to the interface by the system)
Parameters ieee-address — the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff, where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC, and non-IEEE reserved MAC addresses.
To Next Page
Loading...
