VPRN Services
7705 SAR OS Services Guide Page 467
Default no ip-mtu
Parameters octets — specifies the MTU for this interface
Values 512 to 2048
ipcp
Syntax ipcp
Context config>service>vprn>interface
Description This command allows access to the Internet Protocol Control Protocol (IPCP) context within the
interface configuration. Within this context, IPCP extensions can be configured to define such things
as the remote IP address and DNS IP address to be signaled via IPCP on the associated PPP interface.
This command is only applicable if the associated SAP/port is a PPP/MLPPP interface.
Default none
dns
Syntax dns ip-address [secondary ip-address]
dns secondary ip-address
no dns [ip-address] [secondary ip-address]
Context config>service>vprn>if>ipcp
Description This command defines the DNS address(es) to be assigned to the far end of the associated
PPP/MLPPP link via IPCP extensions.
This command is only applicable if the associated SAP/port is a PPP/MLPPP interface with an IPCP
encapsulation.
The no form of the command deletes the specified primary DNS address, the secondary DNS address,
or both addresses from the IPCP extension peer-ip-address configuration.
Default no dns
Parameters ip-address — a unicast IPv4 address for the primary DNS server to be signaled to the far end of the
associated PPP/MLPPP link via IPCP extensions
Values a.b.c.d (unicast only)
secondary ip-address — a unicast IPv4 address for the secondary DNS server to be signaled to the
far end of the associated PPP/MLPPP link via IPCP extensions
Values a.b.c.d (unicast only)
To Next Page
Loading...
