Figure 33: Disturbance recorder – trigger’d recording configuration 97
Figure 34: Disturbance recorder – continuous recording configuration section 98
Figure 35: Traveling waves recorder – trigger’d recording configuration section 100
Figure 36: Steady-state recorder – average series configuration section 102
Figure 37: Steady-state recorder – harmonics configuration section 103
Figure 38: Steady-state recorder – flicker configuration section 104
Figure 39: Adding and editing a group 105
Figure 40: Relays on time configuration section 106
Figure 41: Relay signaling events configuration section 107
Figure 42: MODBUS configuration section 110
Figure 43: Digital Channels Configured 112
Figure 44: Analog channels selected 114
Figure 45: Local interface of the RPV311 119
Figure 46: Status monitoring sequence 121
Figure 47: Monitoring sequence 123
Figure 48: Records monitoring sequence: Fault disturbance, TW and average series 125
Figure 49: Records monitoring sequence: harmonics, flicker and SOE 126
Figure 50: Equipment settings monitoring sequence 128
Figure 51: Circuit and channel settings monitoring sequence 129
Figure 52: Relays, PMU and MODBUS settings monitoring sequence 130
Figure 53: General information monitoring sequence 132
Figure 54: Default screen for browsing on the Web Interface 135
Figure 55: Equipment status screen 136
Figure 56: Link status screen 137
Figure 57: Log screen 138
Figure 58: Manual Trigger screen 139
Figure 59: Fault recorder screen 140
Figure 60: Fault recorder screen 141
Figure 61: Traveling Wave recorder screen 142
Figure 62: Steady-state recorder screen 143
Figure 63: SOE recorder screen 144
Figure 64: Monitoring with plots 147
Figure 65: Monitoring circuit quantities via Web interface 148
Figure 66: Monitoring the status of digital channels 149
Figure 67: Configuration History screen 150
Figure 68: General Information screen 151
Figure 69: Setup screen 152
To Next Page
Loading...