Scanner is accessed through an xml configuration file, where it is possible to configure a list of pieces of
equipment to be scanned in each cycle, the configuration file can be saved either in a standard file
(C:RPVscannerconfconf.xml) or in an alternative file, which in turn can be indicated by command line.
The Scanner can also be started directly of the desktop icon on the desktop created when the user install the
RPV Tools.
2.2.3 EDITING CONFIGURATION FILE
Using Notepad or any other editor, open the xml configuration file located in C:RPVscannerconfconf.xml.
The configuration file must be saved; otherwise, the configuration will be lost.
To configure each RPV311, it is necessary to fill in the file fields as shown below:
Configuration file fields
Time interval between the beginning of a cycle and the
beginning of another, expressed in seconds
<equipment enabled=”xxx”>
Indicates whether the configured RPV will be scanned or
not (yes or no)
<address>xxx.xxx.xxx.xxx</address>
IP address of the RPV to be scanned
Waiting time for communication with the RPV expressed
in seconds
Indicates the type of the record that will be transferred or
saved on the PC. The records can be fault, disturbance,
steady-state, SOE and TW.
Limits or raises the baud rate of the records, where zero
means no baud limits, expressed in KB
Determine whether automatic removal, programmed on
the RPV, will be ignored or not (yes or no)
Enter Yes if communication with the RPV is only by
modem or enter No if the modem is not necessary for,
communication with the RPV
<phonenumber>xxxxx</phonenumber>
Telephone number to connect the modem automatically
The configuration file can be changed during the scanning process. The update will occur in the next
scanning cycle, after the waiting time.
Once the file is configured, scanning will be performed following the configuration of the file whenever the
Scanner is started.
To Next Page
Loading...