Alstom Reason RPV311 - Page 347

RPV311
Chapter 18 – Wiring Diagrams
RPV311-TM-EN-6
347
614
Traveling wave recording finished [at:
]
End of traveling wave recording threshold
exceeded
619
Traveling wave recording refused
(equipment unsync) [at: ]
Trigger rejected due to excess consecutive
triggering protection enabled
630
Traveling wave recorder Ethernet
cross-trigger started [at: ; identifier: ;
location: ; owner: ]
Start of traveling wave recorder Ethernet
cross-trigger detection
631
Traveling wave recorder Ethernet
cross-trigger finished [at: ; identifier: ;
location: ; owner: ]
End of traveling wave recorder Ethernet cross-
trigger detection
632
Traveling wave recorder Ethernet
cross-trigger timed-out [at: ; identifier:
; location: ; owner: ]
Traveling wave recorder Ethernet crosstrigger
exceeded the maximum preset recording time
633
Start of traveling wave recorder
Ethernet cross-trigger ignored [at: ;
identifier: ; location: ; owner: ]
Traveling wave recorder Ethernet crosstrigger
ignored due to another cross-trigger being
recorded by equipment
634
End of traveling wave recorder
Ethernet cross-trigger ignored [at: ;
identifier: ; location: ; owner: ]
Ignored traveling wave recorder Ethernet
cross-trigger finished
650
Traveling wave record available
[name: ; trigger: ; cause ; duration: ]
Indicates the traveling wave record creation
700
Fault recorder threshold exceeded [at:
; threshold: ]
Fault recorder preset threshold exceeded
701
Fault recorder threshold no longer
exceeded [at: ; threshold: ]
Return to normal level for the fault recorder
702
Maximum fault recorder threshold time
exceeded [at: ; threshold]
Indicates the maximum fault recorder
threshold time was exceeded
709
Fault recorder trigger detected [at: ]
Indicates the detection of a fault recorder
trigger
710
Fault recording started [at: ]
Start of fault recording threshold exceeded
712
Fault recording extended [at: ]
Fault recording extended due to threshold
exceeded
714
Fault recording finished [at: ]
End of fault recording threshold exceeded
716
Fault recording timed-out [at: ]
Threshold exceeded the maximum preset
recording time
720
Fault recording refused [at: ]
Trigger rejected due to excess consecutive