Alstom Reason RPV311 - Page 348

Chapter 18 – Wiring Diagrams
RPV311
RPV311-TM-EN-6
348
triggering protection enabled
721
Fault recording disabled [at: ; timeout:
s]
Recording disabled due to fault recorder
repeat in preset time period
722
Fault recording enabled [at: ]
Recorder enable due to threshold exceeded
730
Fault recorder Ethernet crosstrigger
started [at: ; identifier: ; location: ;
owner: ]
Start of fault recorder Ethernet cross-trigger
detection
731
Fault recorder Ethernet crosstrigger
finished [at: ; identifier: ; location: ;
owner: ]
End of fault recorder Ethernet cross-trigger
detection
732
Fault recorder Ethernet crosstrigger
timed-out [at: ; identifier: ; location: ;
owner: ]
Fault recorder Ethernet crosstrigger exceeded
the maximum preset recording time
733
Start of fault recorder Ethernet cross-
trigger ignored [at: ; identifier: ;
location: ; owner: ]
Fault recorder Ethernet crosstrigger ignored
due to another cross-trigger being recorded by
equipment
734
End of fault recorder Ethernet cross-
trigger ignored [at: ; identifier: ;
location: ; owner: ]
Ignored fault recorder Ethernet cross-trigger
finished
740
Fault recorder manual trigger detected
[at: ]
Indicates a manual fault recorder trigger
activated by user
741
Fault recorder manual trigger ignored
[at: ]
Manual fault recorder trigger activated by user
was ignored
750
Fault record available [name: ;trigger:
;cause: ;duration: ]
Indicates the fault record creation
800
Disturbance recorder threshold
exceeded [at: ; threshold: ]
Fault recorder preset threshold exceeded
801
Disturbance recorder threshold no
longer exceeded [at: ; threshold: ]
Return to normal level for the disturbance
recorder
802
Maximum disturbance
recorderthreshold time exceeded [at: ;
threshold: ]
Indicates the maximum disturbance recorder
threshold time was exceeded
809
Disturbance recorder trigger detected
[at: ]
Indicates the detection of a disturbance
recorder trigger
810
Disturbance recording started [at: ]
Start of disturbance recording threshold
exceeded