Installation and Operating Instructions 9
Rear Panel
7. Power Setting — Use this switch to select the correct input
voltage setting: 115 or 230 volts.
8. Mouse — This PS/2-style connector accepts the plug from
the mouse (included with unit) or any other PS/2-style input
device.
9. Keyboard — An optional keyboard can be plugged into this
PS/2-style connector.
10. USB Connectors —These connectors are used to add
RS-232 ports, data storage devices, and other accessories to
the Intellex.
11. VGA OUT — This HD15-S VGA connector provides an
SVGA signal to the Main (SVGA) Monitor to display camera
images and system status.
12. Printer — This DB25-S connector provides the interface
between the unit and the printer.
13. Com2 — This DB9-P connector provides the interface
between the unit and a dome controller (Sensormatic VM16
or American Dynamics ADTT16).
14. Network — This RJ-45 connector connects the unit to a local
area network. The unit supports 10BASE-T (10Mbps) and
100BASE-TX (100Mbps) network operation.
15. Audio Connectors — These are 3.5mm audio jacks to
connect audio input/output .
Green Line Out (Speakers)
Blue Line In
Pink Mic In (Microphone)
NOTE: Even though an external SCSI terminator is not required
on this unit, it may be required on the optional data
storage device.
16. SCSI-3 — This high density 68-pin female connector
provides the interface between the unit and an optional data
storage device.
17. IEEE 1394 interface (FireWire) card — The optional 1394
interface card is installed in this position. This connects to the
optional Extended Storage Module.
To Next Page
Loading...
