Anritsu MT8801C - Page 108

4-53
4.3 CDMA Transmitter and Receiver Test --- TX and RX Tester Mode
• Function keys for Stop State Analog transmitter measurement:
1st page
[Analog TX Measure with SG] F10:
Displays the Analog TX Measure SG screen.
2nd page
[Setup Analog TX Parameter] F9:
Displays the Setup Analog TX Parameter screen.
• Function keys for Stop State CDMA receiver measurement:
1st page (None)
2nd page
[Setup RX Parameter] F9: Displays the Setup RX Measure Parameter screen.
[Setup Signal] F10: Displays the Setup Signal screen.
• Function keys for Stop State Analog receiver measurement:
1st page
[Analog RX Measure] F7: Displays the Analog RX Measure screen.
2nd page
[Setup Analog RX Parameter] F9:
Displays the Setup Analog RX Parameter screen.
• Function keys for Idle State CDMA transmitter measurement:
1st page
[Access Probe Measure] F8: Displays the Access Probe Measure screen.
[Standby Output Power] F9: Displays the Standby Output Power screen.
[Occupied Bandwidth] F11: Displays the Occupied Bandwidth screen.
[Power Meter] F12: Displays the Power Meter screen.
2nd page
[Setup TX Parameter] F9: Displays the Setup TX Measure Parameter screen.
[Setup Gated Power Template] F10:
Displays the Setup Template screen.
[Spurious close to the Carrier] F11:
Displays the Spurious close to the Carrier screen.
[Spurious Emission] F12: Displays the Spurious Emission screen.
• Function keys for Idle State Analog transmitter measurement:
1st page (None)
2nd page
[Setup Analog TX Parameter] F9:
Displays the Setup Analog TX Parameter screen.