Anritsu MT8801C - Page 109

Section 4 Operation
4-54
• Function keys for Idle State CDMA receiver measurement:
1st page (None)
2nd page
[Setup RX Parameter] F9: Displays the Setup RX Measure Parameter screen.
[Setup Signal] F10: Displays the Setup Signal screen.
• Function keys for Idle State Analog receiver measurement:
1st page (None)
2nd page
[Setup Analog RX Parameter] F9:
Displays the Setup Analog RX Parameter screen.
• Function keys for Loop Back and Conversation States CDMA transmitter measurement:
1st page
[Modulation Analysis] F8: Displays the Modulation Analysis screen.
[Gated Power] F9: Displays the RF Power screen.
[Open Loop Power Cont.] F10: Displays the Open Loop Power Cont. screen.
[Occupied Bandwidth] F11: Displays the Occupied Bandwidth screen.
[Power Meter] F12: Displays the Power Meter screen.
2nd page
[Setup TX Parameter] F9: Displays the Setup TX Measure Parameter screen.
[Setup Gated Power Template] F10:
Displays the Setup Template screen.
[Spurious close to the Carrier] F11:
Displays the Spurious close to the Carrier screen.
[Spurious Emission] F12: Displays the Spurious Emission screen.
• Function keys for Loop Back and Conversation States Analog transmitter measurement:
1st page
[Analog TX Measure with SG] F10:
Displays the Analog TX Measure with SG screen.
2nd page
[Setup Analog TX Parameter] F9:
Displays the Setup Analog TX Parameter screen.
• Function keys for Loop Back and Conversation States CDMA receiver measurement:
1st page
[FER Measure] F7: Displays the FER Measure screen.
2nd page
[Setup RX Parameter] F9: Displays the Setup RX Measure Parameter screen.
[Setup Signal] F10: Displays the Setup Signal screen.