5-5
5.1 Preparation for the CDMA Mobile station Measurement
(19) Put the cursor on Power Control Bit Pattern using the Cursor keys. Then
press the Set key of Cursor. Select Closed Loop using the Cursor • keys
when the setting window is opened. Then press the Set key of Cursor to set it.
(20) Press the F6 (Main Func On Off) key to turn On the Main Func.
(21) Press the F1 (TX&RX Tester) key.
(22) Press the F1 (TX Measure) key.
(23) Press the key of Next Menu to display the second page of main function keys
(F1 to F5).
(24) Press the F5 (Start) key. When press the F5 (Start) key, the Call Proc. status
becomes the Idle status (shown below) to wait the Reverse Access Channel sig-
nal from the CDMA mobile station.
To Next Page
Loading...
