APP APP-601 - Re-Initializing the APP Recorder Program; Restart Recorder; Rebooting the APP Recorder Program

Using the APP Recorder 6-38
6.11.7 Re-initializing the APP Recorder Program
You can re-initialize the APP Recorder program to help with troubleshooting.
Note: Re-initializing only restarts the APP Recorder software. Rebooting turns off the entire
APP Recorder machine.
*CAUTION*
The re-initialize command will take the APP Recorder offline for a few
moments.
 To Re-Initialize the APP Recorder Program
1. In the APP Recorder window, from the Maintenance menu, click Reinitialize. You can also
press (F8) at any time except when offline like when displaying oscope.
6.11.8 Restart Recorder
Restart Recorder will immediately EXIT APP Recorder program and then re-start it.
1. In the APP Recorder window, from the Maintenance Menu, select Restart APPRecorder.
2. Recorder will be exited and go Offline.
3. App Monitor will restart APP Recorder within 60 seconds
*CAUTION*
The re-initialize command will take the APP Recorder offline for a few
moments.
6.11.9 Rebooting the APP Recorder Program
You can re-boot the APP Recorder program to help with troubleshooting.
When you reboot, power is momentarily cut to the APP Recorder. The computer and all circuit boards will
see a hard power shutdown. Power is cut via a normally closed relay on the data chassis power supply
circuit board. After 9-10 seconds power will return and the system will restart. It takes approximately
1minute and 30 seconds for the system to return to an online state.
Note: Rebooting turns off the entire APP Recorder machine. Re-initializing only restarts the
APP Recorder software.
*CAUTION*
The APP Recorder will be offline during the restart period.
 To Re-Boot the APP Recorder Program
In the APP Recorder window, from the Maintenance menu, click Reboot. You can also reboot by
pressing F9 anytime except when offline (e.g. when displaying oscope).