Using the APP Recorder 6-28
To Configure Automatic SER Reports
1. Open the Recorder Configuration window and open the Automatic Tasks tab.
2. Select the Auto Print SER Reports On Receipt Printer check box.
3. From the menu bar, click Save.
6.7.15 Calling the Master Phone List when Alarms Occur
You can configure the APP Recorder to automatically call the numbers in the master phone list when
alarms occur. For information on configuring the master phone list, see 6.7.16 Configuring the Master
Phone ListError! Reference source not found..
To Configure whether the APP Recorder Calls the Master Phone List when Alarms Occur
1. Open the Recorder Configuration window and open the Automatic Tasks tab.
2. Under the When Alarms Occurred, Do section, do one of the following:
If you want the APP Recorder to call the numbers in the Master Phone list, select the Call
Master… check box.
If you want the APP Recorder to not call the numbers, de-select the Call Master… check
box.
3. From the menu bar, click Save
Note: The Fault alarm is not affected by the setting of the Call Master… check box.
6.7.16 Configuring the Master Phone List
To configure the master phone list, you can specify:
The phone numbers, IP Address, or Master IDs of the master stations that the APP Recorder
Program will automatically call.
The password APP Recorder should use to log in to the master station
To Next Page
Loading...