APP APP-601 - Setting up Dial-Up Networking

Using the APP Recorder 6-11
13. From the menu bar, click Save.
6.7.4 Setting Up Dial-up Networking
DialNet is for users who want to use Remote Desktop or a similar program to access the recorder using the
same phone line as the recorder. The following is the procedure to set up DialNet. This procedure is also in
Readme.txt located inside of the ClearView directory.
To establish dial-up networking, you must complete the setup procedures on both the APP Recorder
(server) computer and on the ClearView (client) computer.
For Windows XP
 To Set Up Dial-up Networking on the Recorder Computer (Server)
1. On the APP Recorder computer, go to the Network Connections folder (properties under My
Network Places).
2. Click Create new connection and then click Next.
3. Select Setup an advance connection and then click Next.
4. Select Accept incoming connection and then click Next.
5. Under Devices for incoming connection, select only the modem and then click Next.
6. Select Do not allow virtual private connections and then click Next.
7. Under User Permissions, select the users and then click Next.
8. Under Networking Software, check all and select Internet Protocol (TCP/IP) then click
Properties.
9. Under Incoming TCP/IP Properties, select Allow caller to access my local network.
10. De-select Allow caller to specify its own IP address.
11. Select the specify TCP/IP address:
 From: 200.200.200.200
 To: 200.200.200.201
12. Click Next.
13. Click Finish.
14. Complete the procedure, To Set Up Dial-up Networking on the ClearView Computer (Client). Be
sure to select the Dial-up Networking has been setup box.
 To Set Up Dial-up Networking on the ClearView Computer (Client)
1. On the ClearView computer, go to the Network Connections folder (properties under My
Network Places).
2. Click Create new connection and then click Next.
3. Select Connect to the network at my workplace and then click Next.
4. Select Dial-up connection and then click Next.
5. Under Company Name, type the name of this connection and then click Next.
Note: This is the name to use for ClearView.