APP APP-601 - Configuring Automatic Tasks

Using the APP Recorder 6-12
6. Under Phone Number to Dial, type the phone number to the Recorder and then click Next.
7. Click Finish.
8. On the ClearView computer, open the Phone & Network List, choose DialNet, and type in the
connection name that you just created.
Note: Remember to type the connection name. Do not type the IP address or phone
number.
Things to Remember
 The Dial-up network IP Address of the Recorder is (200.200.200.200)
 The Dial-up network IP Address of the ClearView computer is (200.200.200.201)
 Use IP:200.200.200.200 to call the Recorder when using Remote Desktop or UltraVNC or other
remote access services.
 The dial-up network can only be disconnected by the application that started it.
 The dial-up network will stop the Internet connection and also could stop some local LAN.
 The Internet will resume automatically after the dial-up network connection is disconnected.
For Windows 7 and 10
Dial-up Networking using Windows 7 and 10, is supported on a case-by-case basis. To setup Dial-up
networking with Windows 7 or above, please contact APP Engineering support at (317) 536-5300.
6.7.5 Configuring Automatic Tasks
The APP Recorder can perform a variety of automatic tasks, which appear on the window that is shown in
Figure 27. By configuring the automatic tasks, you can take full advantage of the APP Recorder’s ability to
become an integral part of your substation or plant automation.
There are several types of automatic tasks you can configure:
 Automatic tasks that occur when a fault arrives, see Section 6.7.7 including:
 Whether or not the APP Recorder calls the master station, and what type of data it sends about
the fault
 The format of printed reports
 The email settings for automated notifications
 The FTP settings for automated notifications
 Automatic tasks that occur when an SER Event occurs see Section 6.7.14
 Automatic tasks that occur when alarms occur see Section 6.7.15
 Setting up the Master Phone List and the Passwords for login to the Master Station see
Section 6.7.16
Note: The factory configures all of the settings for automatic tasks before shipping the APP
Recorder to you. You can optionally change these settings as needed.