APP APP-601 - Network Path Logon; Figure 49: Network Path Logon

Using the APP Recorder 6-45
1. In the User: box, type the user name for the Windows logon of the APP Recorder.
2. In the Password: box and the Confirm Password: box, type the password for the Windows logon
of the APP Recorder. If no Windows password is set, leave this field blank.
Note: The user name and password must match the Windows account settings.
3. Do you want the APP Recorder to automatically logon to windows when the computer starts?
 If yes, then select the Auto Logon check box.
 If no, then skip to the next step.
4. Do you want the APP Monitor to automatically start when you run the APP Recorder
(recommended)?
 If yes, then select the APP Monitor check box.
 If no, then skip to the next step.
5. Do you want the SpeedFan to automatically start when you run the APP Recorder as an
application?
Note: Speedfan is required for the PC Health Alarm to function due to Hard Drive Temperature
and is required for monitoring Drives with a RAID drive configuration.
 If yes, then select the Speedfan check box.
 If no, then skip to the next step.
6. Click OK.
7. Shutdown and restart Windows
8. Ensure APP Recorder automatically starts when Windows comes back up, if APP Monitor was
selected.
6.13.2 Network Path Logon
This feature is used to automatically log the DFR onto a network drive at APP Recorder Startup or is
reinitialized. Fill in the fields shown to achieve connectivity to the desired network drive. To see if
connection has been established, go to Windows Directory and see if the desired drive is shown and/or
accessible. This feature is in lieu of writing your own batch file that launches when the DFR computer
starts.
Figure 49: Network Path Logon