47System Configurations
Step 3. Use the cursor key to select [ADMIN] field.
When the account field is [USER], you should change to [ADMIN].
Step 4. Use the soft keys to change password or delete password.
Soft key Function
CHANGE PASSWORD Input password(less than 9 numbers).
DELETE PASSWORD The password will be removed.
NOTE: If you forget your password, please send an E-Mail to tech@applent.com.
6.1.4 BeepFeature
Beep Feature can also be set in <LIMIT TABLE SETUP>. (See Page 41, Sector 5.3.5)
To set up the beep feature
Step 1. Press the [Meas] or [Setup] key
Step 2. Press the [SYSTEM] bottom soft key.
Step 3. Use the cursor key to select [BEEP] field
Step 4. Use the soft keys to set beep feature
Soft key Function
OFF Turn off the beep feature.
GD Beep when the comparator sorting result is GD
NG Beep when the comparator sorting result is NG
6.1.5 BeepTone[TONE]
To set up the beep tone
Step 1. Press the [Meas] or [Setup] key
Step 2. Press the [SYSTEM] bottom soft key.
Step 3. Use the cursor key to select [TONE] field
Step 4. Use the soft keys to select beep tone.
Soft key Function
HIGH Buzzer sound high
LOW Buzzer sound low
6.1.6 RS‐232BaudRate
Before you can control the AT281x by issuing RS-232 commands from built-in RS-232
controller connected via its DB-9 connector, you have to configure the RS-232 baud
rate.
The AT281x’s built-in RS-232 interface uses the SCPI language.
The configuration of RS-232
RS-232 configuration is as follows:
Data bits: 8-bit
Stop bits: 1-bit
Parity: none
To set up the baud rate
Step 1. Press the [Meas] or [Setup] key
Step 2. Press the [SYSTEM] bottom soft key.