Applent Instruments AT2818 - Disp:line; Function Subsystem; Function[:Impedance][:Type]

71Command Reference
Example
SEND> DISP:PAGE SYST<NL> //Set to the SYSEMT CONFIG
Query Syntax
DISP:PAGE?
Query Response
<page name><NL>
Example
SEND> DISP:PAGE?<NL>
RET> SYST<NL>
11.6.2 DISP:LINE
The :LINE command enters an arbitrary comment line of up to 30 ASCII characters in
the comment field.
Command Syntax
DISP:LINE “<string>”
Parameter
Where, <string> is ASCII character string (30 ASCII characters)
Example
SEND> DISP:LINE “This is a comment.”
11.7 FUNCtionSubsystem
The FUNCtion subsystem command group sets the measurement function, the
measurement range, monitors parameter control.
Figure11‐3 FUNCtionSubsystemTree
11.7.1 FUNCtion[:IMPedance][:TYPE]
The :IMPedance command sets the measurement function.
Command Syntax
FUNC[:IMPedance][:TYPE] <function>
Parameter
Where, <function> is: