81Command Reference
11.14 CORRectionSubsystem
The CORRection subsystem command group sets the correction function, including the
OPEN, SHORT and LOAD correction settings.
NOTE: The CORRection subsystem CANNOT work in <LIST SWEEP DISPLAY> page.
Figure11‐10 CORRectionSubsystemCommandTree
11.14.1 CORRection:OPEN
The CORRection:OPEN command execute all presetted OPEN correction data
measurement points. (Refer to Page 24 Table 4-10, Table 4-11, Table 4-12 and Table
4-13)
Command Syntax
CORRection:OPEN
Example
SEND> CORRection:OPEN<NL>
11.14.1.1 CORRection:OPEN:STATe
The CORRection:OPEN:STATe command sets the OPEN correction function to ON or