Applent Instruments AT2818 - Correction:short; Correction:load:state

82
AT2818/2816A/2816B/2817A/2817/810A User's Guide
OFF.
Command Syntax
CORRection:OPEN:STATe {ON,OFF,1,0}
Parameter
Where, {ON,OFF,1,0} is:
ON, 1 When the function is ON
OFF,0 When the function is OFF
Example
SEND> CORR:OPEN:STATe ON<NL>
RET> open<NL>
Query Syntax
CORRection:OPEN:STATe?
Query Response
{on,off}
Example
SEND> CORR:OPEN:STATe?<NL>
RET> on<NL>
11.14.2 CORRection:SHORt
The CORRection:SHORt command execute all presetted SHORT correction data
measurement points. (Refer to Page 24 Table 4-10, Table 4-11, Table 4-12 and Table
4-13)
Command Syntax
CORRection:SHORt
Example
SEND> CORRection:SHOR<NL>
RET> short<NL>
11.14.2.1 CORRection:SHORt:STATe
The CORRection:SHORt:STATe command sets the SHORT correction function to ON
or OFF.
Command Syntax
CORRection:SHORt:STATe {ON,OFF,1,0}
Parameter
Where, {ON,OFF,1,0} is:
ON, 1 When the function is ON
OFF,0 When the function is OFF
Example
SEND> CORR:SHOR:STATe ON<NL>
Query Syntax
CORRection:SHOR:STATe?
Query Response
{on,off}
Example
SEND> CORR:SHOR:STATe?<NL>
RET> on<NL>
11.14.3 CORRection:LOAD:STATe
The CORRection:LOAD:STATe command sets the LOAD correction function to ON or
OFF.
Command Syntax
CORRection:LOAD:STATe {ON,OFF,1,0}
Parameter
Where, {ON,OFF,1,0} is:
ON, 1 When the function is ON
OFF,0 When the function is OFF
Example
SEND> CORR:LOAD:STATe ON<NL>
Query Syntax
CORRection:LOAD:STATe?
Query Response
{on,off}
Example
SEND> CORR:LOAD:STATe?<NL>
RET> on<NL>