4-44
Instruments and Programming
X6 - P/N 6525032M1
Management of operator present control
WARNING: Use of the tractor is allowed only if the operator is correctly seated in the driver's seat. An auto-
matic alarm buzzer advises the operator of each improper operation. This buzzer warns that the operator
is non seated in the driver's seat, therefore the tractor cannot be operated safely.
WARNING: Do not tamper with this component in any way.
Contact your Argo Tractors Dealer immediately if the system is not operating correctly.
The instrument cluster includes the operator present alarm logic, that warns the operator if he/she should leave his/her
seat without engaging the parking brake and shifting the gearshift lever to neutral.
The instrument cluster will activate the buzzer according to the following logic:
Case 1: Ignition key OFF
If the parking brake is disengaged, the indicator light "parking brake" flashes and at the same time the buzzer is activate
for 10 seconds until the parking brake is engaged.
Case 2: Engine ON
If the sensor detects the absence of the operator and the gearshift is not in neutral or the parking brake is not engaged,
the buzzer is activated. The indicator light "parking brake" flashes only if the parking brake is not engaged. Alarms are
active until the causing conditions are not satisfied (gearshift in neutral, parking brake engaged or seated operator).
Case 3: Ignition key ON - Engine OFF
If the sensor detects that the operator is not present and the parking brake is not engaged, the buzzer activates and the
indicator light "parking brake" flashes for 5 seconds.
When the operator present switch on the seat activates the buzzer, the following icon is displayed in pop-up mode and
low priority:
To Next Page
Loading...