6-22
Tyres, wheels, ballasting
X6 - P/N 6525032M1
All tractor models are equipped with wholly adjustable
front fenders to ensure the tyre is covered at all tread
widths.
The front fenders provide greater safety and keep the trac-
tor cleaner, therefore improving operation and durability.
To provide the necessary clearance between the fender
and other tractor components, the fender mounting posi-
tion and the total amount of swivel must be adjusted for
the tread width and tyre size being used.
WARNING: Always use the specific PPE for the opera-
tion concerned.
Vertical adjustment
Loosen the support brace mounting bolts (1) and slide
the support brace (2) up or down to the correct position.
Tighten the mounting bolts to a torque of about 50 Nm
(37 Ib ft).
NOTE: The distance between tyre and support brace must
be 50-100 mm (2 to 4 in).
NOTE: The images show, only as an example, an installed
mudguard in the version with suspended axle. The adjust-
ments are the same for the installation with a rigid axle.
FRONT FENDERS
Horizontal adjustment
Loosen the 2 fender bracket mounting bolts (3) on the end
of the mudguard bracket and slide the fender bracket left
or right until the fender is central over the tyre. Tighten
the mounting bolts.
Swivel limit adjustment (if equipped)
(setup with suspended axle)
Loosen the nut (1) and adjust the retainer rod to have the
right amount of mudguard rotation. The retainer rod must
hit the support plate (3) mounted on the axle housing.
Then tighten the lock nut (1).
To Next Page