Maintenance
7-31
7
P/N 6525032M1 - X6
WARNING: If you need to open the bonnet, follow the procedure indicated under "How to open the bonnet".
WARNING: Always use the specific PPE for the operation concerned.
Beware of burns caused by hot water and engine parts. [4.1.n]
STEP 14A
Cleaning of radiators and cooler
Periodically check to make sure that the radiator surface
is not clogged.
WARNING: These operations must be carried
out when the engine is cold. When hot, the
grilles and radiator will burn the hands and
fingers.
Lift the bonnet to access the air conditioning condenser
(1), the transmission oil radiator (2), the aftercooler radiator
(4) and the engine coolant radiator (3).
1. Grasp both ends of the AC condenser (1) and lift it
carefully out in order not to damage the cooling fins.
2. Take out the grid (5).
3. Clean the engine radiator surface (6) by means of an
air jet from the inside to the outside.
4. Clean the transmission oil radiator surface (2) by
means of an air jet from the inside to the outside.
5. Clean the aftercooler radiator (4) with an air jet from
the inside to the outside.
6. Clean the AC condenser surface (1) with and air jet
directed from the inside to the outside.
7. Clean the fuel radiator surface (3) with and air jet
directed from the inside to the outside.
Check that the cooling fins are not warped. In this case
the damage must be repaired.
Proceed in inverse order to remount. Take care not to
damage the cooling fins.
NOTE: We recommend a daily cleaning when front im-
plements are used, especially front mower-conditioners.
To Next Page
Loading...